Leaks in PCP rifles often happens, with this leak then the power and accuracy of the rifle could be disrupted, so it is very annoying in case of leakage.
Leaks occur because of various possibilities as follows:
1. leak in the connection (which is no groove drat), leakage is caused due to imperfect installation of seal (seal) which cover interposed between the threaded groove.
2. Possible again the most severe leakage may soon be known at the time of charging and charged 900-1500psi wind pressure can be in the know with the way hear the wind or touch which was no wind to come out, or by sprinkling the powder, or by applying soapy water on leak-prone points.
3. The possibility of further leaks subtle, or difficult to be detected by means of the above, it can be done in a way that below, as follows::
# Remove the gun stock, riflescope, and other accessories attached pda rifle.
# Remove the barrel of a gun.The trick; Loosen the screws securing the barrel in the top of the box chamber, then pull the barrel forward while playing.
# Remove settings per hammer and a hammer.
# Remove the bolts securing the trigger by opening a trigger which is at the bottom of the box chamber. Once the trigger is released, remove also hammernya.
# Set up a bucket of water.
# Enter the chamber slowly into the water with the tube position facing up to the limit of the tube neck.
# Section leak will be visible air bubbles. Leak-prone areas, among others;
Connections on the neck tube,
The connection between the tube with the chamber,
Close the valve (below the hole where the barrel),
Safety Disk,
Manometer.

Would that the checks carried out on the condition that sufficient light to see air bubbles appear on the leaking section.
Checks can also be by way of a full mengisian wind / gas on the gun and membiarkanya all day with the benchmark see manometer on the gun.
Or to overcome the leakage should be taken only to the alhlinya or workshops rifle nearby.
HOTLINE Hubungi Kami di Contact 081320608661
PENGIRIMAN dengan Kurir Terpercaya
Related Product :